Wednesday, April 10, 2013

Power Supply Failure Alarm

Most of the circuit power supply failure alarm circuits require additional or external power supply. However, this circuit requires no additional power supply. The circuit uses a voltage of 5 volts to 15 volts. To adjust the voltage of this circuit, first connect the power source (5 to 15V) and change the position of potentiometer VR1 until the buzzer buzzer On to Off position.
If the power supply fails, resistor R2 will bias the transistor and the base will turn on the buzzer. Here is a picture series of power supply failure alarm :
 Power Supply Failure Alarm
 Power Supply Failure Alarm  Circuit


No comments:

Post a Comment