If you want to a variable dc voltage power supply circuit during 1.2V to 30Vdc and can provide a current maximum to 5A.
We may be have the many ways such as: to be modified the LM317 Variable Regulator 0-30V 1A by add the power transistor MJ2955 in circuit following Power supply
regulator 1.2V-20V and 3V-6V-9V-12V 3Amp or will build the Variable dc
regulator 0-30V 5A circuit to be well as well, But these methods. Rather
cumbersome and wasting too money.
However we can build this circuit easily and cheap, By using the
packages IC No. LM338 only one, Similar to the LM317 IC number, but it
can supply up to 5A, as the circuit shown in Fig.
How this circuit works
-The transformer T1 converts the AC 220V to 24 Vac, so be rectified the current by the bridge diode rectifier BD1 – 10A 400V. Until DCV has come out that the filter capacitor C1 is equal to 35 volt.
-The IC1 is the heart of the operation of this circuit. By the voltage
output value obtained from the IC depends on the voltage value at the
Adj pin of IC1, or can be varied by adjusting the VR1.
-However output voltage will be approximately equal to 1.25 1.25VR1/R1
The output voltage at the output pin of the IC1 is a more powerful filter with the capacitor C3.
No comments:
Post a Comment